4 Switch Interface Administration

Digital Interfaces

Changing Digital R2 MFC - Mexico Parameters

The E1 circuit card must first be assigned to the Digital R2 MFC - Mexico protocol to use this procedure. See Assigning the Digital R2 MFC - Mexico Protocol to E1 Circuit Cards on page 164 for more information about making the initial assignment.

Note: Before attempting to make any assignment changes to circuit cards, they must be in the “manoos” state. See Equipment State on page 103 in Chapter 3, Voice System Administration , for additional information.

If you change digital protocol assignments on the voice system, you must also make the change on the switch.

To change the Digital R2 MFC - Mexico parameters:

1Start at the Digital R2 MFC Protocol - Mexico menu (Figure 93 on page

164) and select:

>Change Parameters

The system displays the Change Parameters: Digital R2 MFC Protocol - Mexico window (Figure 95 on page 169).

UCS 1000 R4.2 Administration 585-313-507

Issue 3 April 2000 168