A Summary of Commands

detach

•-n— This optional parameter disables prompting from the system whether to wait until a conflict has been resolved (see the -ioption below) or to terminate the request to detach.

•-i— This optional parameter is used to enable secondary command registration. If T1 diagnostics are being run, this option allows the “detaching” of another card. If -iis used and another maintenance command is being run (remove, detach, attach, restore, diagnose), the request to detach is blocked and a message is printed to the screen. If -iis not used and any maintenance command is being run, the request to detach is blocked and a message is printed to the screen.

If the command is permitted to run, a check is made to see if the command is in conflict with another. A command is in conflict if the card or card associated with it:

~Is the T1 card being diagnosed

~Will cause a change in the existing TDM bus master assignment

~Has an interdependency with the T1 card being diagnosed (for example, PRI)

If one of the above conflicts exist and -nis not used, the user is asked whether to wait until the conflict is resolved or to terminate the request. If T1 diagnostics are executing online tests and a conflict is detected, the detach command is blocked. If T1 diagnostics are executing offline tests and a conflict is detected, the user is asked whether to wait until the conflict is resolved or to terminate the request to detach.

UCS 1000 R4.2 Administration 585-313-507

Issue 3 April 2000 424