HP R4.2 remove, rem, all, remove, remove, remove, card#[.port#], A Summary of Commands, <unit> <number> <immed, rem <unit> <number> <immed> <min_delay> [-i] [-n]

A Summary of Commands remove

remove

The remove command places a unit in the manual-out-of-service state.

Synopsis

remove <unit> <number> <immed> <min_delay> [-i] [-n]rem <unit> <number> <immed> <min_delay> [-i] [-n]

Description

The remove command is used to remove a unit from service when its temporary state is idle. It changes the permanent state of the unit to manual- out-of-service (MANOOS). It does not remove a unit that has a temporary state of busy. If a unit must be interrupted immediately or appears to be stuck busy, use the rem <unit> <number> <immed> command.

The parameters for the remove command are:

•<unit> — Identifies the unit. The choices are “channel” or “card.”

•<number> — Specifies the channel or card number, a range of channel or card numbers in the form m-n, or the word all for all the channel or card numbers. Card numbers are in the form card#[.port#] where port# is a port of card#. If port# is not given, all ports of the card specified are removed. If no card number or channel number is given, the system displays a syntax message.

UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 555