A Summary of Commands

start_vs

the start_vs command to start it again. The start_vs also should be used if the system was rebooted or powered down after stop_vs was used.

The start_vs command checks to see if the user stopped the system with the stop_vs command. The start_vs command places all cards placed in the manual-out-of-service (MANOOS) state with the stop_vs command in the in-service (INSERV) state.

You must be logged on to the system console as root to use the start_vs command.

Since the /vs/data/spchconfig file cannot be edited while the voice system processes are running, it is a good idea to check the value of nbufs in the /vs/data/spchconfig file before executing the start_vs command. The value of nbufs defines the number of speech buffers. For the voice system to operate properly, nbufs must be set to 2.5 times the number of active channels.

Example

The following example starts the voice system software:

start_vs

See Also

stop_vs

UCS 1000 R4.2 Administration 585-313-507

Issue 3 April 2000 595