SCSI Utilities
SCSI | Utilities | allow | you to | set delay | times | for the SCSI hard disk |
SCSI | IDs for | SCSI | controllers | installed in | the | system. |
|
|
|
|
|
|
|
| à |
| ð |
| ||
|
| SCSI Utilities |
|
|
| |
| 1. | Harddrive Spin Up Delay |
|
|
| |
| 2. | Change SCSI Id |
|
|
| |
|
|
| . |
|
| |
|
|
| X=Exit |
| ||
| ===>-------- | ' |
|
| ||
|
|
|
| |||
| á |
| ñ |
| ||
|
|
| ||||
|
|
|
|
|
|
|
Using theHarddrive Spin Up Delay time for SCSI hard disk entered manually, or you measured in seconds.
option | allows | you | to change the spin up delay |
drives attached | to | your system. Spin up delay values ca | |
can use | a default | setting (two seconds). All values are | |
Attention: Setting the value lower than the default can prevent successful booting because the system power handling capabilities might be exceeded. If the syst no longer boots after setting this value, access this utility again and increase value. It is also possible that adding disk drives can cause similar symptoms. Changing this value changes the surge current requirements on the system. As you increase the value, the surge current requirements on the system are decreased
Select Console
Select this option to define which display management. If no console is selected, the
is used by the system for system console defaults to Serial Port 1.
à | ð |
Press ð to select this console as the active console
á | ñ |
Chapter 4. Using System Management Services89
