IBM H80 Series manual Sample File modemf0.cfg, Rts

Sample File modem_f0.cfg

#

#COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP ￿Fð

#FUNCTIONS: Modem configuration file for many recent Haye￿s\ compatible modems.

#This example uses the AT&Fð reset command to choose the fac￿tory defaults.

#This set up is preferred for modems with extended (&) comman￿ds. For early

#vintage modems, setup Z or Zð is recommended. If your modem responds to

#the extended (&) commands and to factory default choices (&Fn￿), but doesn't

#work properly with this setup file, setup F1 is recommende￿d.

#

#\ Trademark of Hayes Microcomputer Products, Inc.

#(C) COPYRIGHT International Business Machines Corp. 1996

#All Rights Reserved

#Licensed Materials - Property of IBM

#

#US Government Users Restricted Rights - Use, duplication ￿or

#disclosure restricted by GSA ADP Schedule Contract with￿ IBM Corp.

#If the modem has configuration switches, they should be s￿et to the

#factory default settings.

ICDelay 1
DefaultTO 1ð
CallDelay 12ð
#	AT	Attention Code	,	Inserts delay in dialing commands
# &Fð		Reset. Restore profile ð Qð		Turn on responses
#	Eð	Turn echo off	Q1	Turn off responses
#	Vð	Use numeric responses	Sð=ð	Automatic answer inhibit
# +++		Escape to command mode	Sð=2	Answer on second ring
#	Hð	Hang-up	Xð=ð	Limit modem response codes
#			T =	Tone mode. When used as T\r, it is a
#				no op to maintain program synchronization
#				when modem may/will echo the commands.
#
# &C1		Detect CD	&D2	Respond to DTR (often the default)
# &R1		Ignore RTS (CTS)
#
#	%N	Call-Out phone number	%P	Paging phone number

#%S Modem speed (available to users)

#Following are common responses from a wide range of modem￿s:

#16, 15, 12, 1ð, 5 and 1 are connection responses. Add others as required.

#7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; ð=OK

#

# PROGRAMMING NOTE: No blanks between double quote marks ("￿).

condout:	send "AT&FðQðT\r"	# Reset modem.			Select profile ð
	ignore "ð\r" or "OK\r\n" timeout 2	# Ignore modem			response.
	send "ATEðT\r"	# Initialize modem: Echo OFF,
	expect "ð\r" or "OK\r\n" timeout 2	#	Enable	responses (Numeric),
	send "ATQðVðXðT\r"	#	Limit response codes.
	expect "ð\r" timeout 2	# Confirm		commands successful.
	send "ATSð=ð\r"	# Set AutoAnswer OFF
	expect "ð\r" timeout 2	# Confirm		command successful.
	send "AT&C1&D2&R1\r"	# Detect carrier and DTR,
		#	Ignore	RTS.
	expect "ð\r" timeout 2	# Confirm		command successful.
	done
connect:	send "ATDT%N\r"	# Tone dialing			command.
		# %N from		Call	Home setup.

# Expect a connection response.

Appendix D. Modem Configurations199