Appendix C. Service Processor Setup and Test
For your convenience, an example of a basic Service Processor setup checklist is
included here. Your setup may include more or fewer of the available features, so
you can adjust this checklist for your own application so that it is helpful to you.

Service Processor Setup Checklist

1. Unplug the power cord from the server.
2. Attach a local terminal for this setup procedure.
3. Plug in the server and power on the local terminal.
Attention: Make sure that server power remains off.
4. Bring up the Service Processor menus. See Chapter 3, “Using the Service
Processor” on page 25.
5. Set the system name. See “Privileged User Menus” on page 31.
6. Enable Surveillance. See page 33, and “Service Processor Functions” on
page 61.
7. Configure Call-In/Call-Out. See “Call-In/Call-Out Setup Menu” on page 53.
8. Exit the Service Processor menus.
9. Unplug the power cord from the server.
10. Attach modems (if needed). See page 27.
11. Plug in the server.
Attention: Make sure that server power remains off.
12. Test both of the following:
Call-In, page 174
Call-Out, page 175
Your Service Processor is now ready for use.
Appendix C. Service Processor Setup and Test 173