Muratec MFX-1200, MFX-1600 manual Using the bypass tray, If the paper runs out while copying

Either insert the document in the ADF or place it on the FBS glass.

Basic operation

Using the bypass tray

When you need to use a size of paper not currently loaded in your machine s paper cassette(s), or when you want to use a special type of paper (such as transparency film), use the bypass tray.

Important: If loading transparency (OHP) film into the bypass tray, be sure that the sheet is designed for laser printers and not for copiers. Also, be sure that the film does not have a paper backing and/or a leading strip. If it does, remove the paper backing and/or strip before insert- ing. Only film should go in, not film with any backing or strip.

1

2 Set the paper in the bypass tray.

See the table of Acceptable paper size and cassette capacity on page 1.8 and Loading paper in bypass tray on page 1.10 for more information.

Note: Place the original document in the same orientation as the paper in the paper source (which you ll select in step 5, below).

3 Press PAPER SIZE to select the bypass tray until the light of the bypass tray of the printer status lights on the control panel glows.

4 If necessary, select desired resolution, contrast, reduction/enlargement ratio.

5 Press START to begin the copying process.

Memory overflow message

If you ve stored too much information in your machine s memory, a Memory Overflow message may appear on the LCD:

Memory Overflow

Start Or Cancel

This appears because (1) too many pages have been stored in the memory, or (2) the pages that are stored have too much information on them for your fax machine to remember.

If this message appears, press START to tell your machine to copy as many pages in memory, or press CANCEL to delete from memory all pages stored during the current operation (but not previous operations).

Note: If you don t operate your machine within 60 seconds, the machine will auto- matically print the document stored in the memory during the current operation.

If the paper runs out while copying

When your machine runs out of paper, it beeps, the red light of the printer status lights glows and the LCD shows which source has run out of paper the 1st cassette, 2nd cassette (optional) or the bypass tray.

In this example, the machine runs out of the paper in the 1st cassette:

1st Cassette

Please Supply Paper

If you want to cancel the current copying job, press STOP. Otherwise, supply the paper to displayed paper source to resume the copying.

2.14