Muratec MFX-1600, MFX-1200 manual Sending a fax using the FBS glass, Press Start

Sending a fax using the FBS glass

1	Press COPY/FAX to change to Fax mode.
2	If there s a document in the ADF, remove it.
3	Open the platen cover.
4	Place the document face down on the FBS glass and align it with the docu-
	ment scale on the right, then gently close the platen cover.
	The document should be aligned to the right front corner.
	Important: Gently close the platen cover so that you don t catch your
		hands, possibly injuring them.
		When a thick document, such as a book, is on the FBS glass,
		do not press strongly from the top of the platen cover. This
5		may break the FBS glass and cause an injury.
	Press DOCUMENT SIZE to select the document size, letter (displayed as Ltr),
	legal (Legl) or half-letter (HLtr). (Half-letter is 8.5″ wide 5.5″ tall.)

6 Adjust resolution and contrast if necessary.

Basic operation

7 Enter the fax number.

Also, enter any access codes necessary, just as you would for a regular phone call. (Example: Enter 9 to dial out from an office telephone system, or 1 for long-distance.)

Press Start 919725552009_

8 Press START.

By pressing START, you ve just given your machine a command. In turn, your machine gives this action a command number as it scans the fax document.

This command number appears on the first line of the LCD for a few seconds:

== Command:01 ==

You ll need this command number to cancel the transmission or to print a stored document (see pages 2.8 2.9).

Then your machine will scan the document into the memory.

While your machine scans the document, the LCD will show:

919725552009

Ltr NextDoc Mem100%

9	When the scanning is done, the LCD will show:
		Start Scan →		NextDoc
		Tx Start	→	Start
	If you want to send more pages, proceed to step 10.
	Otherwise, press START to start the transmission, and skip to step 11.
10	Place the next page, then press NEXT DOC to start scanning.
	Note: If necessary, select the document size (see step 5).
	To send any more pages, repeat steps 9-10.
	Otherwise, press START to start the transmission, and skip to step 11.
11	Now, everything is up to the machines yours and the one you re dialing.
	When it makes contact, your machine transmits the stored document from

memory.

Important: If you want to cancel a transmission while scanning the docu- ment, press the STOP key.

If you want to cancel a transmission in progress, use the Review Commands function. See Reviewing or canceling commands, page 2.8.

2.5