NEC VT 300 Series manual Diskette Drive Cabling, PC Card Adapter Cabling

4.If you are installing a CD-ROM drive and your system has speakers, connect the audio cable to the CD In connector on the system board or an audio board (see the instructions that come with the drive).

Diskette Drive Cabling

Cable a diskette drive as follows.

1.Connect the diskette drive signal cable connector to the signal connector on the diskette drive.

2.Locate an available power connector coming from the power supply.

3.Connect the power cable to the power connector on the device.

PC Card Adapter Cabling

Cable a PC card adapter as follows.

1.Connect the connectors at one end of the card adapter cable set to the PC adapter board. The connectors are keyed to fit only one way.

The PC ISA adapter board installs in the ISA expansion slot. See “Installing an Expansion Board” if the board must be installed first.

2.Connect the connectors at the other end of the cable set to the connectors at the rear of the PC card adapter.

The PC card adapter installs in a 5 1/4-inch bay. If the adapter must be installed first, see “Installing a 5 1/4-inch Device” later in this chapter.

Installing Options 4-43