NEC VT 300 Series manual Diskette Drive Signal Cable

IDE Connector Configuration

Configuration	Primary connector	Secondary connector
4 devices (hard drive, hard	Master - hard drive	Master - CD-ROM
drive, CD-ROM, LS-120	Slave - hard drive	Slave - LS-120 drive
drive)
4 devices (hard drive, hard	Master - hard drive	Master - Zip drive
drive, Zip drive, tape	Slave - hard drive	Slave - tape backup
backup)
4 devices (hard drive, hard	Master - hard drive	Master - Zip drive
drive, Zip drive, LS-120	Slave - hard drive	Slave - LS-120 drive
drive)
4 devices (hard drive, hard	Master - hard drive	Master - tape backup
drive, tape backup, LS-120	Slave - hard drive	Slave - LS-120 drive
drive)
4 devices* (hard drive,	Master - hard drive	Master - Zip drive
LS-120 drive, CD-ROM, Zip	Slave - CD-ROM	Slave - LS-120 drive
drive)
4 devices* (hard drive,	Master - hard drive	Master - tape backup
LS-120 drive, CD-ROM,	Slave - CD-ROM	Slave - LS-120 drive
tape backup)
4 devices* (hard drive,	Master - hard drive	Master - Zip drive
LS-120 drive, Zip drive, tape	Slave - LS-120 drive	Slave - tape backup
backup)

*Hard drive must be mounted in top location

Diskette Drive Signal Cable

A diskette drive signal cable comes attached to the system board and to the standard 1.44-MB diskette drive.

The colored edge of the cable goes to pin 1 on the cable connector. Align the red edge of the cable with pin 1 (the notched end) on the drive connector.

4-40 Installing Options