
Installing a 5 1/4-Inch Device
Use the following procedure to install a 5
Note: A 3
1.Follow the preinstallation instructions that come with your device, such as setting jumpers and switches.
2.Remove the left side cover (see “Removing the Left Side Cover” earlier in this chapter).
3.Remove the right side cover (see “Removing the Right Side Cover” earlier in this chapter).
4.Remove the front panel (see “Removing the Front Panel” earlier in this chapter).
5.From the front of the system, slide the device, connector end first, into the device bay (see the following figure). Slide it in far enough for access to the connectors at the rear of the device.
6.Connect the device cables (see “Connecting Device Cables” and “Cabling an IDE drive” earlier in this chapter).
7.Secure the device to the bay with two screws on the left side and one screw on the right side.
If replacing a device in the top bay, use four screws, two to a side.