Advanced Menu - Peripheral Setup
Menu Item | Settings (default is bold) |
Serial Port B Mode | Normal, IrDA, ASK IR |
| Selecting Normal sets the port for normal |
| use, not for IR use. |
IR Duplex Mode | N/A |
IrDa Protocol | N/A |
Onboard Parallel Port | Auto, Disabled, 378, 3BC |
| Select Auto to allow the BIOS to |
| automatically assign the parallel port to an |
| available parallel port IRQ. |
Parallel Port Mode | Normal, |
| Use this mode to choose the operating mode |
| of the onboard parallel port. |
EPP Version | Use this setting (1.7 or 1.9) to select the EPP |
| version. |
Parallel Port IRQ | Parallel port 7 |
| Setting depends on setting of Parallel Port |
| Mode. If not set at auto, you can select the |
| interrupt line for the onboard parallel port. |
Parallel Port DMA Channel | This option allows you to choose DMA |
| channel 1 to 3 for the onboard parallel port in |
| ECP mode. |
Onboard IDE | Disabled, Primary, Secondary, Both |
| The Both setting enables both the primary |
| and secondary IDE controllers. |
Hard Disk Delay Time | Disabled, 3 sec., 6 sec., 9 sec., 12 sec., 15 |
| sec., 21 sec., 30 sec. |
| The hard disk delay time gives the hard disk |
| time to spin up before the system boots. |
|
|
