NEC VT 300 Series manual Advanced Menu - Power Management Setup, Configuring the System, Menu Item

Advanced Menu - Power Management Setup

Menu Item	Settings (default is bold)
Restore on AC/Power Loss	Stay Off, Power On, Last State
	The Power On setting turns power on after a
	power loss. Jumper JP1 must be set for
	Power On (see “Setting System Board
	Jumpers” for procedures on setting JP1).
Ring Resume from Soft Off	Disabled, Enabled
	The Disabled setting causes the system to
	ignore any incoming call from a modem.
	Enabled allows the system to boot up on an
	incoming telephone call. Not supported on
	Windows 98 systems.
LAN Resume from Soft Off	Disabled, Enabled

RTC Alarm Resume from Soft Off

The Disabled setting causes the system to ignore any incoming signal from the LAN network board. Enabled allows the system to boot up on an incoming LAN signal from the network board.

Disabled, Enabled

When Enabled, you can choose the time the system boots up (see the following time settings).

RTC Alarm Date	Sets the day that the system boots up (when
	RTC Alarm Resume is Enabled).
RTC Alarm Hour	Sets real time clock alarm hour (when RTC
	Alarm Resume is Enabled).
RTC Alarm Minute	Sets real time clock alarm minute (when RTC
	Alarm Resume is Enabled).
RTC Alarm Second	Sets real time clock alarm second (when RTC
	Alarm Resume is Enabled).

Configuring the System 3-15