
Power On Mode
Your system can be jumpered to start up in one of the following two ways:
Twhen the power button is pressed
when the power cord is connected (“Immediate Boot Up”).
To change the way your system starts up, change the jumper setting on jumper block JP1.
1.Power off the system and monitor and unplug any peripherals.
!WARNING
The system power must be off before removing the cover and changing a jumper setting.
2.Remove the left side cover (see “Removing the Left Side Cover” in Chapter 4).
3.Locate JP1 on the system board (see the figure “Locating system board jumpers” earlier in this chapter).
4.Set jumper JP1 as follows.
Set the jumper on pins 1 and 2 to allow system boot
Tup when the power button is pressed.
Remove the jumper from pins 1 and 2 for immediate system boot up when the power cable is connected. To prevent loss of the jumper, “park” it on pin 1 only.