NEC VT 300 Series manual Tshield

5.Remove the blank plastic panel from the bay by pressing the panel tabs from inside the front panel and pushing the blank panel out.

Save the panel for future use if you remove a device and don’t replace it (see “Replacing the Front Panel” for procedures to reinstall the plastic panel).

Locating the blank panel tabs

A – Blank Panel Tabs

6.Remove the metal shield from the bay where you are installing the device (see the figure “Removing the front panel” for shield location).

Insert a screwdriver into one of the holes in the metal

Tshield.

Twist the shield with the screwdriver until it comes loose.

7.Install the device (see “Installing a 5 1/4-Inch Device” later in this chapter).

Installing Options 4-47