Omron NT31 NT31C manual Made by JAE, Cables with Connectors Made by Omron

Connecting to the Host’s RS-232C Port					Section 5-1
	Name		Model	Remarks	Delivered with
					C-series CQM1, C200HS,
		XM2S-0911		9-pin type	C200HX/HG/HE(-Z)E
				Made by OMRON	CVM1/CV-series CPUs
					CV500-LK201
		XM2S-0913		Made by OMRON 9-pin	---
	Connector
		XM2S-0911-E		Made by OMRON 9-pin	CS1 series CS1G/CS1H
	hood
				25-pin type	C500-LK203
		XM2S-2511			3G2A5-LK201-EV1
				Made by OMRON
					C200H-LK201-V1
		DB-C2-J9		25-pin type	3G2A5-LK201-EV1
				Made by JAE	3G2A6-LK201-EV1
		AWG28 5P		Multi-core shielded cable	---
	Cable	IFVV-SB		Made by Fujikura, Ltd.
		CO-MA-VV-SB		Multi-core shielded cable	---
		5P	28AWG	Made by Hitachi, Ltd.

Cables with Connectors Made by OMRON

When connecting an NT-AL001 and a PC, use the OMRON cables with connec- tors indicated in the table below.

Model	Cable Length	Connector Specification
XW2Z-200S	2 m	9-pin ⇔ 25-pin
XW2Z-500S	5 m	Host link, NT link (1:1)
XW2Z-200T	2 m	9-pin ⇔ 9-pin
XW2Z-500T	5 m	Host link, NT link (1:1)
SJ45007-102	1 m	9-pin ⇔ 9-pin
		Host link, NT link (1:1)
SJ45007-202	2 m	+5 V power supply wire attached
		(Use when the PC does not have a +5 V output.)
XW2Z-070T-1	0.7 m	9-pin ⇔ 9-pin
		Host link, NT link (1:1), NT link (1:N)
XW2Z-200T-1	2 m	+5 V power supplied from PC
		(Use when the PC has a +5 V output.)
SJ46006-102	1 m	9-pin ⇔ 9-pin
		Host link, NT link (1:1), NT link (1:N)
SJ46006-202	2 m	+5 V power supplied from PC
		(Use when the PC has a +5 V output.)

Note The maximum tensile load of the recommended cable is 30 N. Do not exceed this load.

•After connecting a connecting cable, always tighten the connector screws.

•Recommended connectors, cables and crimp terminals for RS-422A/485

When making an RS-422A/485 connecting cable, as far as possible use the recommended parts indicated in the table below. Some units come supplied with one connector and connector hood.

Check the required parts and prepare them in advance.

98