Omron NT31 NT31C manual Soldering, Hood Assembly, Assemble the connector hood as shown below

Making the Cable Appendix E

5. Wrap vinyl tape over the cut off end of the shielding wire.

(1)

(2)

40 (1.57) (RS-232C)

25 (0.98) (RS-422A)

(3)

(4)

5 (0.19)

(5)

Units: mm (inch) Vinyl tape

Soldering

1, 2, 3... 1. Slide heat-shrink tube over each wire.

2.Pre-solder each wire and connector terminal.

3.Solder each wire to each connector terminal.

1 mm

Soldering iron

Heat-shrink tube (F, 1.5 mm dia., ￿ = 10 mm)

4. Push the heat shrink tube over the soldered joint and heat the tube to shrink it in place.

Heat-shrink tube

Hood Assembly

Assemble the connector hood as shown below.

	Aluminum foil tape
End connected to FG	End not connected to FG

268