Omron NT31 NT31C manual Setting the Start-up Wait Time, Memory Switch Settings

System Settings Section 6-9

The four memory switch setting screens are shown below.

[] (next screen)

[] (next screen)

[] (previous screen)

[ ] (previous screen) [ ] (next screen)

[] (next screen)

[] (previous screen)

[] (previous screen)

Memory Switch Settings

A list of the memory switch settings is presented below.

• Start-up Wait Time	page 169
• Key Press Sound	page 170
• Buzzer Sound	page 171
• Printer Controller	page 172
• Print Method	page 174
• Screen Saver Movement	page 175
• Screen Saver Start up Time	page 177
• Hist. Disp. Method	page 179
• Resume Function	page 181
• Comm. Auto-return	page 183
• Time-out Interval	page 185
• Retry Counts	page 186
• Comm. A Method	page 157

(For the bar code reader, refer to page 188.)

• Comm. B Select	page 167
• Comm. B Method	page 157

For details on each setting, refer to the pages indicated.

6-9-2 Setting the Start-up Wait Time

The Start-up Wait Time is the time lapse until the NT31/NT31C switches to the RUN mode after its power has been switched ON or after it has been reset. Set this item if it takes some time for the host to start operation. Nothing is displayed during the Start-up Wait Time.

The setting range is 0 to 10 seconds. The default (factory) setting is 00sec.

169