Panasonic MN101C77C, F77G user manual External interrupts with/without noise filter

Chapter 1 Overview

< Serial interface interrupts >

-Serial interface 0 reception interrupt (Full-Duplex UART)

-Serial interface 0 transmission interrupt (synchronous + Full-Duplex UART)

-Serial interface 1 reception interrupt (Full-Duplex UART)

-Serial interface 1 transmission interrupt (synchronous + Full-Duplex UART)

-Serial interface 3 interrupt (synchronous + single master IIC)

-Serial interface 4 interrupt (slave IIC)

< A/D interrupt >

- A/D converter interrupt

<Automatic transfer controller(ATC) interrupt > - ATC 1 interrupt

5 External interrupts (with/without noise filter)

-IRQ0 : Edge selectable. Both edges interrupt.

-IRQ1 : Edge selectable. Both edges interrupt. AC zero cross detector.

-IRQ2 : Edge selectable. Both edges interrupt.

-IRQ3 : Edge selectable. Both edges interrupt.

-IRQ4 : Edge selectable. Both edges interrupt. Key interrupt function.

Timers
7 timers ( 6 can operate independently )
- 8-Bit timer for general use	2 sets
- 8-Bit timer for general use (UART baud rate timer)	2 sets
- 8-Bit free-running timer	1 set
Time base timer	1 set
- 16-Bit timer for general use	1 set

Timer 0 ( 8-Bit timer for general use )

-Square wave output ( Timer pulse output ), PWM output,

Event count, Remote control carrier output, Simple pulse width measurement

-Clock source

fosc, fosc/4, fosc/16, fosc/32, fosc/64, fs/2, fs/4, fx, external clock

Timer 1 ( 8-Bit timer for general use )

-Square wave output ( Timer pulse output ), Event count,

16-Bit cascade connection function ( connected to timer 0 ), Timer synchronous output

-Clock source

fosc, fosc/4, fosc/16, fosc/64, fosc/128, fs/2, fs/8, fx, external clock

I - 4 Hardware Functions