Panasonic MN101C77C, F77G user manual Characteristics

Chapter 1 Overview

1-5-3			DC	Characteristics
						Ta=-40 oC to +85 oC VDD=1.8 V to 3.6 V VSS=0 V
			Parameter		Symbol	Conditions		Rating		Unit
							MIN	TYP	MAX
	Power supply current (not load at output pin) *1
	1				IDD1	fosc=20.00 MHz,VDD=3.3 V		6	12
						[fs = fosc/2]
										mA
	2				IDD2	fosc=8.39 MHz,VDD=3.3 V		3	6
						[fs = fosc/2]
		Power supply current
	3				IDD3	fx=32.768 kHz,VDD=3.3 V		10	20
						[fs = fx/2] Ta=25 oC
	4				IDD4	fx=32.768 kHz,VDD=3.3 V			40
						[fs = fx/2] Ta=-40 oC to +85 oC
	5				IDD5	fx=32.768 kHz,VDD=3.3 V		5	10
		Supply current during				Ta=25 oC
										∝A
	6	HALT1 mode			IDD6	fx=32.768 kHz,VDD=3.3 V			40
						Ta=-40 oC to +85 oC
	7				IDD7	VDD=3.3 V		0	2
		Supply current during				Ta=25 oC
	8	STOP mode			IDD8	VDD=3.3 V			30
						Ta=-40 oC to +85 oC

*1 Measured under conditions of Ta=25 °C, without load.

-The supply current during operation, IDD1(IDD2), is measured under the following conditions: After all I/O pins are set to input mode and the oscillation is set to <NORMAL mode>, the MMOD pin is connected to VSS level, the input pins are connected to VDD level, and a 20 MHz (8.39 MHz) square wave of VDD and VSS amplitude is input to the OSC1 pin.

-The supply current during operation, IDD3(IDD4), is measured under the following conditions:

After all I/O pins are set to input mode and the oscillation is set to <SLOW mode>, the MMOD pin is connected to VSS level, the input pins are connected to VDD level, and a 32.768 kHz square wave of VDD and VSS amplitude is input to the XI pin.

-The supply current during HALT mode, IDD5(IDD6), is measured under the following conditions: After all I/O pins are set to input mode and the oscillation is set to <HALT mode>, the MMOD pin

is connected to VSS level, the input pins are connected to VDD level and an 32.768 kHz square wave of VDD and VSS amplitude is input to the XI pin.

-The supply current during STOP mode, IDD7(IDD8), is measured under the following conditions: After the oscillation is set to <STOP mode>, the MMOD pin is connected to VSS level, the input pins are connected to VDD level, and the OSC1 and XI pins are unconnected.

I - 22 Electrical Characteristics