Perle Systems 5500320-12 manual Introduction

Introduction

Parameter added:password-script <password>

Command:set user

Parameter added:password-script <password>

Command:set server

Parameter added: ssl-passphrase-script<password>

Command:set snmp v3-security readonly

Parameter added:auth-password-script <password>

Command:set snmp v3-security readwrite

Parameter added:privacy-password-script <password>

Command:add radius auth-host<host>

Parameter added:secret-script <password>

Command:add radius accounting-host<host>

Parameter added:secret-script <password>

Some commands require a “Y/N” reply. When these commands are used with the Device Scripting feature of PerleVIEW, the following behavior will be applied with no user interaction required.

save – would do the save.

netload firmware – Will not reboot of chassis.

netload text-config - Will perform the save config. Will not perform the reboot. slot reset [factory] – Will perform the resetting of slot or config

set config-to-factory-default - Will perform the setting of current config to as the factory default configuration.

set chassis management_module_slot - Will not perform the reboot.

netload media-converter - If ‘automatically updating of media module firmware’ is enabled, then display message that this cannot be over-ridden in script mode otherwise, go ahead and save file.

During netload commands, the CLI will not output the progress messages. This takes time, bandwidth and will be of no use in a Device Scripting implementation. A series of dots are output to provide the batch mode with periodic traffic to prevent the process from timing out.

Device Scripts 142