Polycom VSX Series manual Configuring StereoSurround Settings, Points to note about StereoSurround

Customizing the VSX System

Configuring StereoSurround Settings

To send or receive stereo audio, make sure your VSX system equipment is set up as described in Connecting Microphones or a SoundStation VTX 1000 on page 2-19and Connecting Speakers on page 2-26. Then configure the system to use Polycom StereoSurround, test the system configuration, and place a test call.

If you are in a call with a far site that is sending audio in stereo mode, you can receive in stereo. In multipoint calls where some sites can send and receive stereo and some sites cannot, any site that is set up to send or receive stereo will be able to do so.

Points to note about StereoSurround:

• Camera tracking is disabled when you enable StereoSurround.

•If StereoSurround is enabled on a VSX 6000 or VSX 7000, the system cannot record audio from a call.

For information about other features that are not compatible with StereoSurround, refer to the troubleshooting information on page 7-27.

To configure systems to send and receive Polycom StereoSurround:

Go to this screen:	Configure these settings:
Audio	Set Enable Polycom StereoSurround.
System > Admin Settings > Audio
Audio Levels	Set Subwoofer Speaker to Off.
System > Admin Settings > Audio >
Audio Settings > Next > Next
VSX 7000, VSX 7000s

4 - 25