Polycom VSX Series manual Select and configure these settings

Configuring Network Use

3.Select and configure these settings:

Setting	Description
DNS Servers	Displays the DNS servers currently assigned to the system.
	If the system does not automatically obtain a DNS server address,
	enter up to four DNS servers here.
	Changing this setting causes the system to restart.
Default	Displays the gateway currently assigned to the system.
Gateway	If the system does not automatically obtain a gateway IP address,
	enter one here.
	Changing this setting causes the system to restart.
Subnet Mask	Displays the subnet mask currently assigned to the system.
	If the system does not automatically obtain a subnet mask, enter
	one here.
	Changing this setting causes the system to restart.
WINS Server	Displays the WINS server currently assigned to the system.
	If the system does not automatically obtain a WINS server IP
	address, enter one here.
	Changing this setting causes the system to restart.
WINS	Sends a request to the WINS server for WINS name resolution.
Resolution
LAN Speed	Specify the LAN speed to use. Note that the speed you choose
	must be supported by the switch.
	Choose Auto to have the network switch negotiate the speed
	automatically. If you choose 10 Mbps or 100 Mbps, you must also
	select a duplex mode.
	Note: Be sure that the device and the switch settings match.
	Typically, selecting Auto for both is sufficient. The LAN Speed
	setting for the VSX system and the switch must match. Polycom
	strongly recommends that you do not select Auto for either just
	the VSX system or just the switch; the settings for both must be
	the same.
	Changing this setting causes the system to restart.
Duplex Mode	Specify the Duplex mode to use. Note that the Duplex mode you
	choose must be supported by the switch.
	Choose Auto to have the network switch negotiate the Duplex
	mode automatically.
	Changing this setting causes the system to restart.

3 - 5