Ricoh IS300e operating instructions Simplex Scanning, 113

Original Orientation

Simplex Scanning

The setting orientation differs depending on whether the width of original is within or larger than 297mm (11.7”).

Original width		297mm (11.7”) or less					wider than 297mm (11.7”)
	Place the original so that the top					Place the original so that the top
When placing an original	edge touches the top-left of the					edge touches the top-left of the
on the exposure glass	exposure glass.					exposure glass.
⇒ p.116 “Placing the
Original on the Exposure
Glass”
	Place the top edge of the original					Place the original so that the top
When placing originals	first.					edge is set on the far side of the
						original table.
on the ADF
⇒ p.117 “Placing the
Originals in the ADF”
	Set [Orientation:] to				.	Set [Orientation:] to					.
Setting when the net-	When the ADF is used, set [Side:]					When the ADF is used, set [Side:]
	to “ Simplex ”.					to “ Simplex ”.
work TWAIN driver is		Note						Note
used
	❒ Set “ ADF ” or “ Platen glass					❒ Set “ ADF ” or “ Platen glass
		” *1	in [ Document: ].					” *1	in [ Document: ].
Settings for Send Scan	Select [			: 1 Sided].		Select [				: 1 Sided].
(Use [Original Settings] in
[Scan Settings] )		Note

❒Because this is the initial val- ue of this setting, you do not need to change it.

*1 Contact glass: Select when scanning from the exposure glass.

4

113