Ricoh IS300e operating instructions Press Next three times, Press OK Use ↑ and ↓ to display

System Settings

To configure network boot settings when you use this machine on a DHCP environment

APress [Next] three times.

“5. Access Control ” appears as the setup item currently select- ed.

Note

❒It is not necessary to specify “2. IP Address ”, “3. Subnet Mask ” and “4. Default Gate- way Address ”. The DHCP server on your network as- signs these values automati- cally.

BSpecify each value for “5. Ac- cess Control ” and “6. Network Boot ”.

You can specify these values in the same way that you have done in steps B through E un- der p.55 “To configure network boot and related settings when a fixed IP address is assigned to this machine”. When you are finished, “7. Network Boot ” ap- pears as the setup item current- ly selected.

Note

❒When you want to set no lim- itation of access to this ma- chine, it is not necessary to specify “5. Access Control ”, while you need to confirm that “6. Access Mask ” is set to “000.000.000.000”.

CPress [OK].

D Use [↑] and [↓] to display “

DHCP ”.

Note

❒“*” mark appears along with the option currently selected.

E While “ DHCP ” is displayed,	3
press [OK].

This returns to the System Set- tings menu.

Note

❒Pressing [Cancel] leaves the setting as it was (the option marked with “*” remains ac- tive), and returns to the pre- vious screen.

G Press [Next].

“8. Delivery Server IP Address ” appears as the setup item currently selected.

Note

❒This item is automatically con- figured when you register this machine to a delivery server op- erated by ScanRouter V2 Profes- sional/Lite. Press [OK] to confirm this setting after you have registered this machine to a delivery server, and then press [Cancel] to return to the System Settings menu.

The setting screen for “7. Net- work Boot ” appears.

57