If the finisher option is not installed on the equipment, the default output tray will be used (inner). If the finisher option is not installed on the equipment, the default output tray will be used (bin 2).
Example: The command to specify output bin 1 is “lp
For e-STUDIO4511 Series:
“jsp1” and “jsp2” are not available for
— Hole Punching
When the hole punch option is installed it can be activated using the following option.
Option Value | Alternate | Description |
| Value |
|
|
|
|
|
|
|
punch=0 | nopunch | Hole punching is turned off. |
|
|
|
punch=1 |
| Hole punch long edge without rotation. |
|
|
|
punch=2 |
| Hole punch short edge without rotation. |
|
|
|
punch=3 |
| Hole punch long edge with 180 degree rotation. |
|
|
|
punch=4 |
| Hole punch short edge with 180 degree rotation. |
|
|
|
If this option is not specified, the default value of “nopunch” will be used.
This function is not available for all paper sizes and the users should refer to the copier manual for a list of compatible paper sizes. In particular, A5, A6 and statement paper sizes will not
work with this function.
Example: The command to hole punch the long edge feed portrait page is “lp
— Media Type
The paper source can also be selected using the media type using the following option.
Option Value | Alternate | Description |
| Value |
|
|
|
|
|
|
|
mtype=Plain |
| The paper source that contains Plain paper is requested. |
|
|
|
mtype=Trans- |
| The paper source that contains transparency slides is requested. |
parency |
|
|
|
|
|
mtype=Thick |
| The paper source that contains Thick1 paper is requested. |
1 |
|
|
|
|
|
mtype=Thick |
| The paper source that contains Thich2 paper is requested. |
2 |
|
|
|
|
|
mtype=Thick |
| The paper source that contains Thich3 paper is requested. |
3 |
|
|
|
|
|
In PostScript Deferred Media Selection is always turned on so the paper size has priority over the media type and the paper source.
In PCL5e the paper size always has priority over the media type and the paper source. If this option is not specified, the default value will be used.
Example: The command to specify Thick1 media type is “lp
312 | Printing Guide — Printing from UNIX |
