Toshiba 3511, 200L, 280, 230L, e-Studio 350 manual Finishing Options, Destination

— Finishing Options

In the Finishing Options menu, you can set the destination, hole punching and stapling features.

1

2

3

1)Destination

This selects the output destination tray.

•Inner Tray — Select this to route the output to the inner tray.

•Job Separator Upper — Select this to route the output to the upper tray of the Job Sep- arator. (e-STUDIO450 Series and e-STUDIO280 Series Only)

•Job Separator Lower — Select this to route the output to the lower tray of the Job Sep- arator. (e-STUDIO450 Series and e-STUDIO280 Series Only)

•Tray 1 — Select this to route the output to the upper tray of the Finisher.

•Tray 2 — Select this to route the output to the lower tray of the Finisher.

NOTE: • “Tray 1” and “Tray 2” are only available when the Single-staple Finisher, Multi-staple Finisher, or Saddle-stitch Finisher are installed.

•When the optional Job Separator is installed and configured on the Configuration tab, you can select “Job Separator Upper” and “Job Separator Lower” instead of “Inner Tray”.

2)Hole Punch

This sets whether or not a print job is hole punched.

•Off — Select this to print without hole punches.

•Long Edge Punch without rotation — Select this to create holes on the left side for the portrait document, or on the top for the landscape document.

280 Printing Guide — Printing from Macintosh