104
- RECEIVING“AUTO RECEIVE” is the ability of the facsimile to receive docu-
ments sent to your facsimile automatically.
The facsimile starts to receive a document after a pre-selected num-
ber of rings. You can change the ringer count (see page 62).
NOTE:
A ring delay can be selected should you wish to speak to the
calling party before receiving a facsimile.
If you do not pick up the handset within the selected delay
period, the facsimile will automatically answer the call and at-
tempt to receive a document.
This mode is used together with a TAD (telephone answering device/machine).
This mode allows you to receive voice messages and facsimile receptions even when no one is present
in the office.
Switching between the voice message recording and facsimile receiving is performed automatically.
FAX Monitor Time: When the voice message recording is completed earlier than the FAX Monitor Time, the
line will be switched to the facsimile side. However, if the voice message recording
exceeds the time value, the line will not be switched to the facsimile side.
(1) Caller in Automatic Facsimile Transmission Mode
When the facsimile signal is detected during or after the TAD Answering Message switching is
automatically made for Facsimile Reception mode.
(2) Caller Attempting a Phone Call
After the TAD Answering Message and the TAD Beep Tone, the TAD will record the message from
the caller.
(3) Caller in Manual Facsimile Transmission Mode (may first leave a voice message if within the FAX
Monitor Time)
When the caller starts a facsimile transmission during the Answering Message or after the TAD Beep
Tone, switching is made for Facsimile Reception mode.