Toshiba DP80F, DP85F manual Direct Transmission as Default Setting

Direct Transmission

Direct Transmission is used if there is not enough residual memory or when a large num- ber of document pages are to be sent, etc.

This mode is also useful if the operator wishes to visually con- firm the actual transmission of

Direct Transmission as Default Setting

1 Load the Document	2 Dial the Facsimile	3 Start Dialing	4 Line Connection to
	Number		the Remote Party

the document to the remote par- ty.

The documents will remain in the ADF and be transmitted one by one.

This procedure will discuss Di- rect Transmission when se- lected as the default setting or when Residual Memory has been depleted.

Load the document face down in the Document Support (see page 82).

Adjust the resolution and con- trast if desired (see pages 83 and 84).

MAY-17 09:43 AM 100% AUTO RECEIVE

Example of screen displayed when Residual Memory has been depleted:

MAY-17 09:43 AM 0%

AUTO RECEIVE

Dial the facsimile number of the remote party using any of the four dialing methods.

•One Touch Key Dialing

... See page 89

•Abbreviated Dialing

... See page 90

•Alphabet Dialing

... See page 91

•Keypad Dialing

... See page 92

•Press if a dialing er- ror occurs.

Example of screen displayed while a number is entered using Keypad Dialing:

TEL NUMBER =(MAX128) 0559761234

Once the facsimile number is entered, the dialing starts.

DIALING

0559761234

If the destination facsimile is busy, the screen below is dis- played.

WAITING TO REDIAL AUTO RECEIVE

If the redial procedure is com- pleted without a success, the screen below is displayed and printed the Transmission Re- port.

MAY-17 09:43 AM 100% PRINTING LIST

After printing

Once connected to the destina- tion facsimile, the screen below is displayed.

COMMUNICATING +81 559 761234

MAY-17 09:43 AM 100% LINE BUSY

95