Toshiba DP80F, DP85F Dialing with Sub-Address, Load the Document Display the SUB, Address Comm

Dialing with Sub-Address

This function attaches a sub-ad- dress to the standard destina- tion address in the event the re- mote party requires one.

1 Load the Document

2 Display the SUB

ADDRESS COMM

Menu

3 Select the Option	4 Enter the SUB
	Address

Three types of sub-addresses can be used (SUB, SEP, and PWD); or any combination of two or three types can be used. After selecting the desired types, the transmission to follow will be sent to the desired ad- dress using the designated sub- address.

You can activate this option while programming an Abbrevi- ated Dial Number (page 65) or One Touch Dial Key (page 71) if communication with a certain re- mote party always requires this option.

If you activate this option using both an Abbreviated Dial Num- ber (or One Touch Dial Key) setting and using this procedure for the same destination, this operation will take precedence over the pre-programmed set- ting in the Abbreviated Dial or One Touch Dial.

NOTE:

For more information on when to use SUB/SEP/PWD, refer to page 69. If you des- ignate an erroneous or un- necessary sub-address, the communication will result in an error.

Load the document face down in the Document Support (see page 82).

Adjust the resolution and con- trast if desired (see pages 83 and 84).

MAY-17 09:43 AM 100% AUTO RECEIVE

Press:

+

+

+

+

SUB ADDRESS COMM. 1.DONE

2.SUBADDRESS SUB

3.SUBADDRESS SEP

4.SUBADDRESS PWD

Select one of the following op- tions from the menu.

To select SUB, press:

Go to Step 4.

To select SEP, press:

Go to Step 5.

To select PWD, press:

Go to Step 6.

To complete this procedure, press:

Go to Step 7.

Enter the required SUB address (max. 20 digits), then press:

The display returns to the screen at the bottom of Step 2. You may continue from Step 3 and enter another sub-address of a different type. To complete your sub-address entry, select option “1.DONE” in Step 3.

173