Toshiba DP85F, DP80F manual Quick Start, Terminal ID, Transmitting Receiving

- QUICK START

This section provides several quick start programming steps to prepare your new facsimile for immediate use.

Terminal ID

1 Setting the Terminal ID (Page 42)

Transmitting	Receiving
2 Sending a Facsimile	3 Receiving a
(Page 93)	Facsimile (Page 104)

These procedures are a simple version of the detailed proce- dures listed in the manual. Next to each procedure heading is a convenient page number refer- ence for the detailed procedure. Should you have any difficulty with these simple procedures, refer to the pages listed for more information.

Press: , ,

NAME (40MAX)

[]

FAX NUMBER (20MAX)

[]

Enter your facsimile’s telephone number, press:

Load your document face down into the Document Support.

MAY-17 09:43 AM 100% AUTO RECEIVE

Dial the remote facsimile using

Your TOSHIBA facsimile has been preset from the factory to receive facsimile messages. No special setup is required to re- ceive facsimile messages.

It is highly recommended that you take the time to read through this manual to get the most from your new TOSHIBA facsimile.

Enter your user ID (company name) using the Numeric Key- pad, press:

COUNTRY CODE 1.YES

2.NO

COMPLETED

Displayed for 2 seconds

INITIAL SETUP 3.TERMINAL ID

the Dial Keypad located on the Operation Panel. Remember to include any access numbers

such as 9 or press the

after the access number if you normally have to wait for a dial tone.

If you communicate internation- Press: ally, select:

Otherwise, select:

After the remote facsimile num- ber has been entered into the keypad, press the green START key.

34