Toshiba DP80F, DP85F manual Enabling or Disabling Send after Scan Temporarily

Enabling or Disabling Send after Scan Temporarily

If the Send After Scan Mode Default Setting is set to “OFF”, this feature allows you enable the Send After Scan mode for a single transmission. Once that

1 Load the Document

2 Display the SEND AFTER SCAN Menu

3 Select the Send	4 Select the Memory
After Scan Option	Full Option

transmission is complete, the default status is regained.

If you enable Send after Scan, you will be given the opportunity to select “SEND SCANNED PAGES” or “CANCEL SEND- ING.”

Select “SEND SCANNED PAG- ES” if you want the pages scanned to memory (prior to the Memory Full) to be transmitted. Select “CANCEL SENDING” if you want to cancel that trans- mission and try again later when more memory is available or use a Direct TX operation.

Load the document face down in the Document Support (see page 82).

Adjust the resolution and con- trast if desired (see pages 83 and 84).

MAY-17 09:43 AM 100% AUTO RECEIVE

Press:

+

+

+

+

SEND AFTER SCAN

1.ON

2.OFF

Select the desired Send After Scan Option.

To enable Send After Scan, press:

UPON MEMORY FULL

2.SEND SCANNED PAGES

1.CANCEL SENDING

Go to Step 4.

To disable Send After Scan, press:

The following is displayed for 2 seconds.

COMPLETED

Go to Step 5.

Select the desired Memory Full Option.

To cancel the pages that have been scanned, press:

To send the pages that have been scanned, press:

The following screen is dis- played. You may dial the remote facsimile for your communica- tion job. The display will return to the Standby Mode in about 60 seconds if no keys are pressed.

MAY-17 09:43 AM 100% ENTER TEL NUMBER

175