Quick & hot deluxe Niagara.qxd:Cafet Tefal Express 01_FR. qxd 10/06/09 14:28 Page 10
Using your appliance
1 - Fill the water tank with cold water. (fig. 12)
2 - Place the water tank onto the appliance and then close the lid onto the water tank. Press the water tank firmly into place.
(fig. 6)
3 - Plug the appliance in.
4 - Place a cup under the nozzle. To obtain hot water, briefly press the hot water button and you will automatically obtain 220 ml of hot water. Adjust the height of the nozzle by pulling the rubber grip up or pushing it down. (fig.13)
5 - If you wish to stop the water before the end of the cycle, press the hot water button again. (fig. 7)
6 - Depending on the model you have, to obtain ambient water, follow the same procedure but use the ambient water button, which produces 200 ml of water automatically dispensed at room temperature. (fig. 14)
NB : If you would like to get ambient water after the hot water has been running, fill half a mug and discard it or wait for a minimum of 5 minutes.
Setting the cup quantity
Quick & Hot Deluxe is already
To change the programmed amount :
1 - Fill the water tank with cold water.
2 - Push the water tank firmly into place.
3 - To set up the hot water quantity, press and hold the hot water button. Once the desired amount of hot water is reached, release the hot water button. The new hot water quantity is now programmed.
4 - If your model has an ambient water button, to set the quantity repeat the above steps pressing the ambient temperature button.
Descaling
Descaling should be carried out every 2 months (or after 500 cycles) or for models with descaling indicator, descaling should be done when the orange light flashes on the control panel. (fig. 15)
1 - Place a 1.7 litre container under the nozzle.
2 - Remove the Claris filter cartridge. Fill the tank with 1 litre of white vinegar. (White vinegar is available from hardware stores).
3a - For models with descaling indicator:
•Press and hold the hot and ambient water buttons simultaneously for approximately 10 seconds.
•The orange light will remain on during descaling and white vinegar will intermittently spread through the circuit of the appliance to break down the scale.
Descaling will last approximately 10 minutes
•At the end of the descaling cycle, the orange indicator light will turn off. (fig. 11)
3b - For models with only one button and no orange indicator:
•Press the hot button several times to empty the tank.
4 - For all models:
•Refill the water tank, and rinse the appliance following the ‘Rinsing your appliance section’.
NB : If the orange light flashes during use you may need to descale the appliance as soon as possible.
Protecting the environment
Help protect the environment!
Your appliance contains valuable materials which can be recovered or recycled. Leave it at a local civic waste collection point.
10