Connecting ATM media Modules
After setting the ATM address, you must connect the ATM media modules to the network. This is necessary because the factory default setting isolates them from
receiving | network | traffic. |
|
|
| |||
To connect | an ATM | media module, | you use the SET MODULE command: | |||||
|
|
|
|
|
|
| ||
|
| ONcoreATM> set module 3 connected | [ENTER] |
| ||||
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Afterwards, | you can | enable individual ports | on | the | module and configure an ATM | ||
interface | for | each | port. This | requires the | SET | PORT | command and is described in the |
next section, | “Enabling | ATM Ports | and Interfaces” | on page | |||
