Troubleshooting |
| Phase | 4 | Problems |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
To | troubleshoot | Phase | 4 | problems, | an | 3Com service engineer needs the information | |||||||||||||||||||||
listed | in | this | section. Note | that | in | order | to | record trace information, perform dumps, | |||||||||||||||||||
upload | the | error | log, | you | must use | a | TFTP | file |
| server | in | IP | over | ATM | or | LAN | emulation | ||||||||||
mode. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
For | information | on how to record trace information, see “Troubleshooting Phase 3 | |||||||||||||||||||||||||
Problems” | on | page | For | information | on | how | to | upload | the | trace | or | error | log file, | ||||||||||||||
see “Uploading | and Downloading Operations” on page |
|
|
|
|
|
|
|
|
|
| ||||||||||||||||
| Types | and slot | numbers |
| of | all | modules | installed | in | the | hub, | displayed by | the SHOW | ||||||||||||||
| MODULE | ALL | VERBOSE | command. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
| ONcore | hub | information configured using Distributed Management Module (DMM) |
|
| ||||||||||||||||||||||
| commands |
| and | displayed by entering the SHOW | DEVICE, | SHOW | HUB, | SHOW |
|
|
| ||||||||||||||||
| MODULE ALL, and SHOW MODULE VERBOSE | commands. |
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||||||||
| ONcore | hub | information | configured | using | 6416SW |
| commands | and | displayed | by |
|
| ||||||||||||||
| entering | the | SHOW ATM_ESI, SHOW DEVICE, SHOW HUB (if DMM module not |
|
|
| |||||||||||||||||||||
| installed), SHOW LAN_EMUL CONFIGURATION_SERVER, SHOW |
|
|
|
|
|
|
|
|
|
|
| |||||||||||||||
| LOGICAL_LINK, | SHOW MODULE | ALL, | SHOW MODULE | VERBOSE, | SHOW |
|
|
|
|
|
|
|
|
|
| |||||||||||
| PORT | ALL | VERBOSE, | and | SHOW | STATIC_ROUTE | commands. |
|
|
|
|
|
|
|
|
|
|
|
|
Type and characteristics of each ATM device attached to the hub
ON/OFF condition and color of the LEDs on each module installed in the hub.
Last 6416SW commands entered from the local console.
Error log information uploaded to the host by entering the UPLOAD command.
Trace information uploaded to the host by entering the UPLOAD command
Dump information uploaded to the host by entering the UPLOAD command
The following reports generated from ONdemand ATM Campus Manager
Version 1:
– | atmSvcTable from | the | atmSw | MIB |
|
– | atmSvcClearTable | from | the | atmSw | MIB |
– | interfaceTable | from | the | atmSw | MIB |