To do so, use the SHOW | command. For example, to view information on the status of |
the ports in the hub, use the SHOW MODULE ALL command: | |
ONcoreATM> show module all | [ENTER] |
Slot Install Connect Operation General Information
1 | Y | n | n | - |
2 | n | n | n | - |
3 | n | n | n | - |
4 | Y | Y | Y | ONcore ATM 1 Mbps UNI Module |
5 | n | n | n | - |
6 | n | n | n | - |
7 | n | n | n | - |
8 | n | n | n | - |
9 | Y | Y | Y | ONcore ATM Switch/Control Module |
1 | Y | n | n | - |
11 | n | n | n | - |
12 | Y | n | n | - |
13 | Y | Y | Y | ONcore ATM 155 Mbps Module |
14 | Y | n | n | - |
15 | Y | n | n | - |
16 | n | n | n | - |
17 | n | n | n | - |
ONcoreATM>
The following example shows the output of a SHOW MODULE n VERBOSE for a