either get a new source (re-install the source file from your installation package), or, if it fails again, contact your 3Com Service or 3Com representative.

8. Message:Flash memory failure/hardware-error

.

Try to download several times. If it always fails, contact your 3Com representative.

9. Message:Target Blade Mismatch

.

You tried to download FPGA picocode that is incompatible with the target module number. Check the type of module (6404M-100, 6402M etc.) and the

TFTP parameter.

ATM hub cannot restart after a download inband operation is performed and

TFTP-supported services are operational.

Steps to Take:

1.Use the DOWNLOAD OUT_OF_BAND command to load the microcode that was previously active. Then restart the hub.

2. If the hub still does not start, replace the 6416SW module in the hub.

3. Contact your 3Com service representative.

7-38 ONcore ATM Switch/Control Module: Installation and User's Guide

Page 168
Image 168
3Com 6416SW manual MessageFlash memory failure/hardware-error