3Com 6416SW manual Switch Name

Setting		Local		6416SW	Parameters
The	6416SW		is	pre-configured with default		settings	that may	need	to	be	changed befor
you	can	use		the switch. To modify these		6416SW	parameters,	you	must	log	on using
the	system		administrator		password. Then use	the SET command to		change		the	values
for any of the following:
	6416SW name
	Contact		name	and location
	Console prompt
	Console	timeout value.

A brief description of each parameter is given in the following sections. For more detailed information, ONcoresee theSwitching Hub/CELLplex 4000 ATM Command

Reference Guide.

Switch Name

In order to simplify the command parameters						you need to enter to perform certain ATM
tasks, you can assign a unique name to each						6416SW. You can then use this name
instead		of	the	IP address to identify the		6416SW.
To set		a	unique	name for the 6416SW,	enter	the SET DEVICE NAME command and
press Enter.
	￿ONcoreATM> set device name [6416SW name]				[ENTER]

5-10 ONcore ATM Switch/Control Module: Installation and User's Guide