Diagnosing | Problems | with | ATM | Ports |
|
|
|
| ||
If | all | ATM | modules are operationalconnected,(hardware okay, andnormal displayed |
| ||||||
with SHOW MODULE VERBOSE), the cause of the problem may be due to an | ||||||||||
inoperational | ATM | port. To | see if the ATM ports | on a given | module | are | functioning | |||
correctly, | use | the | SHOW | MODULE and SHOW PORT commands to | display | port | status. | |||
Any | of | the | following | types of port status may | appear: |
|
|
| ||
Unknown
Error
No Activity
Not In Service
Okay
Okay
The | problem | associated with | each port status (except for Okay) and the action to ta |
to | solve it | are described | below. |
Status: Unknown
Explanation: Port status is not available because port is not reachable.
Steps to Take:
1.Use the SHOW MODULE command to check if the ATM media module is connected to the 6416SW module.
2.If the ATM media module is not connected, use the SET MODULE command to set
thenetwork parameterconnectedto .
If the module is connected, reset it using the RESET MODULE command.
3. The | FPGA | of | the | module is not compatible with the FPGA or microcode of the |
6416SW. Check | the | prerequisites in the release Note.. | ||
4. If | the | problem | persists, replace the ATM media module. | |
