Setting | Up | a | Configuration | Console | in | SLIP Mode | |
The | procedure | that follows | sets up | the | configuration console in SLIP mode and logs you | ||
on | as | the | system administrator with | full | access to all 6416SW commands. |
Note: A typical workstation includes two serial ports (COM1, COM2):
One dedicated to an
The other dedicated to an IP stack and supported via the SLIP protocol.
Both ports are needed for this procedure.
1. Connect | your | workstation | to | the | port | on the |
| front panel | of the | |||||||||||||
6416SW | from | the | serial | port. |
|
|
|
|
|
| ||||||||||||
2. Configure | the | terminal | in | Normal | mode | and | logon | as administrator as described in | ||||||||||||||
“Setting | Up | a | Configuration |
| Console | in | Normal (ASCII) Mode” on page |
| ||||||||||||||
3. If | a | data | transmissionother thanrate9600 | is | required, use the SET TERMINAL |
| ||||||||||||||||
BAUD | command | to | configure | a data | transmission | rate. |
|
|
|
| ||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||||||
|
| ONcoreATM> set terminal baud 192 |
|
| [ENTER] |
|
|
|
|
|
| |||||||||||
|
|
|
|
|
|
|
|
| ||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||||||
4. Set | the local | IP | address | (6416SW) | and | remote | IP | address |
| (workstation) | for the | |||||||||||
SLIP | protocol | using | the | SET |
| TERMINAL | SLIP_ADDRESSES | command. |
|
|
|
| ||||||||||
|
|
|
|
|
|
|
| |||||||||||||||
|
| ONcoreATM> set terminal slip_addresses | [ENTER] |
|
|
|
|
| ||||||||||||||
|
|
|
|
|
| |||||||||||||||||
|
|
| Enter local ip address : 9.1 |
| .86.139 |
| [ENTER] |
|
|
|
|
|
| |||||||||
|
|
| Enter remote ip address : 9.1 | .86.138 | [ENTER] |
|
|
|
|
| ||||||||||||
|
|
| ONcoreATM> |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
5.Switch the configuration console port operating mode to SLIP using the SET TERMINAL CONSOLE_PORT_PROTOCOL command.
| ONcoreATM> set terminal console_port_protocol slip | [ENTER] |
| ||||||
|
|
|
|
|
|
| |||
6. Unplug | the cable from the | serial | port | and plug it into the | |||||
serial | port of your | workstation. |
|
|
|
|
| ||
| ATM Switch/Control | Module: Installation | and User's | Guide |