No Connection Between Two ATM Clusters in the Same Subnetwork
Steps to Take:
1. Use the SHOW PORT command to:
Make | sure that | the ATM media port at each end | of the connection is configured |
with | an NNI interface. If not, use the SET PORT | commandNNI asand specify | |
the | interface | parameter. |
|
Make sure that the status ofOKAYeach.Ifportnot,is follow the procedure described in “Diagnosing Problems with ATM Ports Attached to ATM Devices” on page
2. Use the SHOW DEVICE command to:
Make sure that the ATM address of each hub is configured with the same Routing Domain number (RDN).
Make sure that each boundary hub is | configured | with | a | different ATM Cluster | |||
number | (ACN). |
|
|
|
|
| |
3. Use the | SHOW LOGICAL_LINK | command to make | sure that | the | logical link settings | ||
of the | ATM | media port on | each boundary | hub are correctly | configured. | ||
4. Contact your 3Com service representative.
