Upgrading

FPGA

Picocode in

ATM Modules

 

To upgrade

hardware picocode in the FPGA of

6416SW and ATM media modules,

enter

the

following

commands at the directory

prompt:

1.SET TFTP SERVER_IP_ADDRESS (to define the server where the picocode is stored)

2.

SET

TFTP

FILE_NAME (to define

the file

on

the server)

3.

SET

TFTP

FILE_TYPE (to specify FPGA)

 

 

4.

SET

TFTP

TARGET_MODULE (to specify the

slot

number of the 6416SW or ATM

media

module)

 

 

 

5. DOWNLOAD

INBAND (to load new

hardware

picocode)

6.SWAP FPGA_PICOCODE (to change the picocode in the module). This causes an automatic reset of the ATM subsystem.

Uploading Dumps

To upload

a

dump

to

the

host, enter

the following

6416SW commands at the directory

prompt:

 

 

 

 

 

 

 

1. DUMP

TRS

(to

take

a

dump of the

topology of

the network)

2.SET TFTP SERVER_IP_ADDRESS (to define the server connected to the 6416SW module)

3.

SET

TFTP

FILE_NAME (to define the

path name of the file on the host)

4.

SET

TFTP

FILE_TYPE (to specify a

dump)

5. UPLOAD

INBAND (to upload the dump).

6-7

Page 127
Image 127
3Com 6416SW manual ATM Modules, Uploading Dumps, Dump TRS