
Diagnosing Problems from the ATM Media LEDs
The following section details problems that can occur with ATM media modules.
WRONG SLOT LED is ON. |
|
|
|
| |
Explanation: | Either | the | ATM backplane | is | not installed in the ONcore or the ATM |
media module has | been | inserted in | an | incorrect slot. | |
Steps to | Take: |
|
|
|
|
1. Check that the backplane is installed (in the upper part of the ONcore).
2. | Check | that | the | ATM | media | module | has | not | been | inserted in an incorrect | slot | (slot 9, | ||||||||||||||||
10, | or | 11), | which is | reserved | for | ATM | Switch/Control modules. |
|
|
|
|
|
|
| ||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
No LED | is | ON. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Explanation: |
| This | is | the | default | behavior | when | you | install | an | ATM | media | module | that |
| |||||||||||||
has | never | been | used; | the | ports | are disabled | so | no | light | is | on. If | this |
| is | not | the | ||||||||||||
follow | the | steps | below. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||
Steps |
| to | Take: |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
1. Check | that | the | module | is | connected | to | the | backplane | correctly. | Unplug | the | module, | ||||||||||||||||
then | plug it back in carefully. When | you feel | that | the | module | is | almost | inserted, | ||||||||||||||||||||
the | levers | to | push | it |
| in | completely. (see | Figure | on | page |
|
|
|
|
| |||||||||||||
2. | If | the | ports | are | not enabled, check that the | module | is | working | correctly | by | issu | |||||||||||||||||
the | SHOW | MODULE | and | SHOW | PORT | commands. |
|
|
|
|
|
|
|
|
|
|
|
|
|
3.Check that the power budget has not been exceeded. Before adding a power supply, check that this is the real cause, by issuing the SHOW POWER BUDGET
command. If | a | DMM module | is installed, this command | must be issued from the |
DMM console. If necessary, add a power supply. |
| |||
Refer to3ComtheONcore Hub | Installation and | |||
if there is | a | problem | associated with the power | budget. |