ATM Connection Problems

No Connection between Two ATM Hub in the Same Cluster

Steps to Take:

1. Use the SHOW PORT command to:

Make

sure that

the ATM media port at each end

of the connection is configured

with

an SSI interface. If not, use the SET PORT

commandSSI asand specify

the

interface

parameter.

 

Make sure that the the status ofOKAYeach.If portnot, isfollow the procedure described in “Diagnosing Problems with ATM Ports Attached to ATM Devices” on page 7-20.

2. Make sure that the bandwidth specified is the same at both ends of the trunk.

3. Contact your 3Com service representative.

7-47

Page 177
Image 177
3Com 6416SW manual ATM Connection Problems