3Com 6416SW manual Saving Reconfigured Configuration Console Settings

Reconfiguring

6416SW

Configuration

Console

Settings

Carry

out

the

procedures

in this

section only

if

you

need

to

connect

another

device

(besides

the

6416SW

configuration

console)

to

the

6416SW,

and

if

the

other

device runs at

a

slower baud rate, uses a

different

parity,

or

has

a different

data

bit

value

than

the

6416SW's

pre-configured

factory

settings.

For

example,

if you want to connect

a

4800

baud

modem

to the 6416SW to remotely

manage

the

hub, you

must change

the factory-set default baud rate from 9600 to 4800.

To

do

so,

you

would

enter

the

following command:

￿ONcoreATM> set terminal baud 48

[ENTER]

See theONcore Switching Hub/CELLplex 4000 ATM Command Reference Guidefor information on the SET TERMINAL commands that allow you to reconfigure configuration console settings.

Saving Reconfigured Configuration Console Settings

After

you

use

the SET

TERMINAL

command

to

reset

the

baud

rate,

the

parity,

or

the

data bit value for the 6416SW, the change is activated immediately and you lose

communication

with the configuration console. The

new

configuration

console setting

is

not,

however,

permanently

saved.

In order to save the configuration console parameters

that

you

reconfigure

with

the SE

command,

you

must

connect

the

new configuration

console

to

the 6416SW,

log

on,

and

enter

the

SAVE TERMINAL command. Once saved in this way,

the

new

configuration

console settings remain stored in memory after

you

log

off

and

in case

of

a

power

failure.

For more

information

on how to

reconfigure

and

save

configuration

console

settings,

see the sections describing the SET TERMINAL commandsONcorein Switchingthe

Hub/CELLplex

4000

ATM

Command

Reference

Guide.

4-15