You | can | configure | multiple | logical | links | over | the same physical port. However, | you | can | ||||||||||||||
only configure one logical link (using one pair | of | ATM | ports) for | each | ATM |
|
|
| |||||||||||||||
|
|
|
|
|
|
|
| ||||||||||||||||
Using | Static | Routes |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
In | an | ONcore/CELLplex | 4000 ATM network, you can | only set a logical link to | a | cluster |
| ||||||||||||||||
number | (ACN) | that | is | defined within your own ATM | subnetwork. In | order to | set | up a |
| ||||||||||||||
logical | link | with | a | remote | cluster | outside | your own subnetwork, you must | use | the | SET | |||||||||||||
STATIC_ROUTE | command | to | assign | an ACN | to | the | network | prefix | of | the boundary | hub |
| |||||||||||
of | each | remote | cluster | to | which | you | want | to | link. The SET | LOGICAL_LINK | command |
| |||||||||||
then | will | be | able | to set up a connection | to | this | logical | hub | using | its | assigned | ACN. | |||||||||||
Trunks |
| Within | a | Single | Cluster/Subnetwork |
|
|
|
|
|
|
|
|
|
|
|
|
| |||||
To define | a | logical | link | between | switches | within the same cluster or subnetwork, use th | |||||||||||||||||
SET LOGICAL_LINK command to set the following | parameters | for | each | port | in | each |
| ||||||||||||||||
switch: |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Virtual Path Identifier (VPI) number
ATM cluster number (ACN) for the remote switch
Bandwidth available on the virtual path
Signalling role for Q.2931 protocol.