
7.Configure the IP stack SLIP with the IP address of the 6416SW and verify the
|
| C:\ping 9.1 | .86.138 | [ENTER] | ||
|
|
|
|
| ||
8. Start a TELNET | session | to the | 6416SW. | |||
|
|
|
| |||
|
| ONcoreATM> telnet 9.1 | .86.139 | [ENTER] | ||
| ||||||
|
|
|
|
|
|
|
9. Logon as administrator. The Welcome screen is displayed:
Password:
Welcome to system administrator service on ONcore.
ONcoreATM>
You can now proceed to configure the 6416SW, as described in Chapter 5, “Configuring the ATM Switch/Control Module” on page
Returning to Normal Mode
To switch the configuration console port back to Normal mode, use the SET TERMINAL CONSOLE_PORT_PROTOCOL command.
ONcoreATM> set terminal console_port_protocol normal | [ENTER] | |
|
|
|
Note: An 6416SW RESET restores the configuration console port to NORMAL operating mode.