
91
Diskette drive
Replacing the diskette drive
1Turn off power to the server and unplug the AC power cords from the power source.
2Remove the front access panel (refer to page 46).
3Remove the fan modules and the foam fan baffle (refer to page 86).
4Disconnect the power and signal cables from the back of the diskette drive.
5Remove the screw that secures the diskette drive bracket to the chassis.
6Remove the bracket and drive assembly from the inside of the front subchassis.
7Position the drive and bracket so that the bottom of the bracket is facing up.
8Holding the front of the drive with one hand, tilt the front of the bracket up to disengage the locating pins on each side of the bracket from the drive.
9Slide the bracket back and remove it from the drive.