74 | 3 Hardware configuration |
To remove a PCI add-in board from a non-hot-plug slot
1Disconnect the AC power cords from the power source or wall outlets.
2Turn off all peripheral devices connected to the server system.
3Remove the rear access panel (refer to page 44) and the system board access panel (refer to page 51).
4Release the latches on the front and rear retention mechanisms.
5Grasp the board by the top edge or corners, carefully pull it out of the connector, and slide it free of the retention bracket.
6If you are installing a new board, follow the instructions on page 73.
If you are not installing another PCI
7Install a slot cover over the vacant slot in the back panel.
8Install the system board access panel and the rear access panel. For instructions, refer to page 52 and page 45 respectively.
9Turn on any peripheral devices connected to the system.
10Connect the power cord and turn on power to the server.